A lightweight UV stabilized Thermoplastic material. Soft white in color with good chalk resistance, this tubing machines easily and works well with most glues. Epoxy is recommended for installation. XTC hits slightly softer than the Melamine materials. Not recommended for use in Jump/Break Cues, or for use with any coolants or solvents containing hydrocarbons when machining as the material may break down. Use of Synthetic Coolants or Solvents is fine. Each ferrule is approximately .562 in diameter and 1.100" in length. The drilled and tapped ferrules are 5/16-18 and 3/4" deep with an overall length of 1.065". They're ready to install as all the work has been done for you. They're faced off smooth and even, drilled and tapped to perfection. Prices as follows: Solid Per 1.................. $ 1.25 Solid per 10................. 10.95 Drilled and tapped per 1..... 2.00 Drilled and Tapped Per 10.... 17.50 |